commvault.com commvault.com
Solved

How do I deploy the file recovery enabler for Linux (FREL)?

  • 30 December 2020
  • 4 replies
  • 2335 views
C
Rank
Badge +2

Any pointers with deploying FREL?

icon

Best answer by Jordan 31 December 2020, 01:27

View original

4 replies

J
Rank
Userlevel 5
Badge +11

Hi Christine,

 

This is a common question, so we made a video tutorial on how to deploy it to support restore operations from Linux filesystems.  

 

Check it out here: How to Deploy a File Recovery Enabler for Linux (FREL)

 

Let me know if you have any further questions at all.

 

Thanks 

H
Rank
Badge

Hi @Sebastien Merluzzi ,

Thanks for your reply. We are working on this configuration. If facing challenges/issues, I will post again seeking your guidance. 

Regards. 

H
Rank
Badge

Hello,

The video shared on this thread points only to VMware and OpenStack. Do you have any video or guide to configure the FREL for Oracle Linux Virtualization Manager? I went through the documentation but have some doubts, to be specific on below point:

 

  1. Add a disk or volume with the XFS file system and create the following mount point for cache data:

    • For FBR cache: 40 GB minimum

Which mount point should we use, is it a new one with any specific configuration?

Hope you could help me, thanks in advance.

S
Rank
Userlevel 6
Badge +12

Hi @Hansel ,

There is no specific configuration:

You just need to create an independent device(disk partition or logical volume), then mount it.

For ex:  mount it to /opt/FBR and then add "dFBRDIR /opt/FBR" in Session reg key.

Best Regards,

Sebastien

Reply


Terms & ConditionsCookie settings