Solved

When Commserve livesync failover to standby server?

  • 15 July 2022
  • 3 replies
  • 107 views

Userlevel 1
Badge +6

Hi,

 

I understand that conditions must be satisfied before a failover (CS Livesync) is automatically executed (if enabled)

I have a question about this.

Does this immediately happen after these conditions are met or does it wait and checks it the conditions a (few) minutes later again before going over?

And if that there is some delay, is it configurable?

 

Thanks,

Danny

icon

Best answer by Orazan 15 July 2022, 16:40

View original

3 replies

Userlevel 6
Badge +15

Good morning.  The delay is not configurable, at least not at this time.  The conditions are that we check that the connections are good both ways every five minutes as well as checking several other settings in the registry.  If these fail, it will initiate the auto-failover.

Userlevel 1
Badge +6

Thank you Orazan,

So to be short, failover will happen between 1 sec and 5minutes if all conditions are satisfied

Userlevel 6
Badge +15

Yes that is correct.  😀

Reply