@Noushad received the following “These models are End of Sale from the manufacturer and aren't available for purchase. They are all still fully supported by Commvault and will be until the hardware reaches End of Support with the manufacturer.”

So from a CV perspective, you are good and will be supported. 

They are fixing the deprecation notice on books online which is wrong.

Hope this helps!

Regards,

Chris 

@Noushad 

From what I can tell, reviewing internal docs, it’s supported in FR32, but not in FR34+. 

Only Apollo 4200 Gen 10 Plus is supported onwards.

I’ll get books online updated.

Regards,

Chris 

@Chris Hollis

Thank you for the response.

so this mean i can proceed to install Hyperscale X in an existing commserv environment with version 11.32.42 using Apollo 4200 Gen10 right ?

@Noushad yes, I believe so. To me, this applies to new installs/appliances only. 

@Scott H when you get capacity, could you please help here?

Regards,

Chris 

@Noushad please give me a few days to sync with my development team and get confirmation. 

Hi @Noushad ,

You can, but then what will happen once you upgrade to FR34/FR36?

Best Regards,

Sebastien

@Chris Hollis @Scott H 

Thank you for the response.

so if i install Hyperscale X now using Apollo 4200 Gen10 to existing commserv with version 11.32.42 , then can i later upgrade commserv to 11.34 or 11.36 and will Apollo 4200 Gen10 based Hyperscale X nodes still function normally ?

@Chris Hollis Sure, thank you for the response.

@Chris Hollis 

Thanks a lot for the confirmation!