Command Console Hyperscale Hardware Report is only displaying a new 3 node HSX cluster. How do I add existing Hyperscale 1.5 nodes to this report?
Thanks
Best answer by Stuart Painter
View originalCommand Console Hyperscale Hardware Report is only displaying a new 3 node HSX cluster. How do I add existing Hyperscale 1.5 nodes to this report?
Thanks
Best answer by Stuart Painter
View originalHi
As you have a specific example, it would be useful and productive at this stage to raise a support case so that we can look at the specifics with your Commserve database, logs etc. and go further than we can here in the Community forum.
Please raise a support case and private message me the case number so that I can track internally.
Thanks,
Stuart
Hi
There are a couple of different reports/dashboards in Command Center that appear to show different features, please would you confirm which one you’re referring to?
This report shows hardware configuration details for HyperScale X Ref Architecure:
HyperScale X - Ref Architecture - Verifying the Default Configuration
This Dashboard shows HyperScale 1.5 Appliance nodes:
Once you clarify specifically which report you’re looking at, we can check to see the best way to show all your HyperScale nodes.
Thanks,
Stuart
Hi I got to the command center dashboard and click on hardware components
I don’t want to share want comes up from there as it has system names. We had a hard drive fail on one of the hyperscale nodes. I found it by drilling down into some other reports. But it would be nice if i saw a failure in the hardware components Disk tile that currently shows all good.
Thanks
Here is the report I am interested in
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.