Hi,
Do we have an option to deploy HyperScale 1.5 on an environment without DNS? I have CS 11.24 on a cm and deploying 3node CV HS 1.5. I already set the Data & Storage n/w (10Gig bonded), but got stuck at below stage. It do not allow unless you don’t enter a dns? Is there a way to accomplish it?
DNS is required by the underlying storage system, so it’s not optional or possible to not use DNS.
Hi Mike,
Thanks for response. I have a look on the below link. This if for ref. architecture, but if its work of ref. architecture, if should work for CV HS also.
Setting Up HyperScale Storage Nodes With Static IP (commvault.com)
This link using ./setupsds for setup, and 10th point in the link says:
Please share you input on this.
Thanks,
Anuj
Hi
DNS is required for the Data Protection Network:
DNS is optional for the StoragePool Network:
Best Regards,
Michael
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
