Hi,
I have a new install on Ref Arch version 11.32
I am going through the “what to do next” BOL to make sure all is secure.
For the Firewall I run # firewall-cmd --state but I do not get a response telling me the state of the firewall.
I run another cmd I found systemctl status firewall and it replies.
Any reason why the CV cmd in BOL does not work ?
Checked my HSX 2.0 and “firewall-cmd --state” returns the expected “running”
are you on HSX 3.x? if so might be a issue in the new Image
yeah, on HSX 3.2312
I just ran the firewall-cmd --state on the other two nodes and on Node 2 it replies running but Node 3 I get no response from the cmd.
I connected to the Node over iDRAC and tried the cmd’s and they ran there with replies.
Now I know.
I don’t know if it’s the issue, but the screen shot has an extra # before the command.
Thanks,
Scott
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
