Hi All.
I have a HyperScale 1.5 setup, with HBA cards installed on the nodes to be able to do VSA SAN backups.
I have configured the multipath.conf to use round-robin, so the HBA card will utilize both ports on the card
I have noticed that even though round-robin have been configured, it seems that only on port is utilized and that the port being used is then being maxed out.
Do I miss somewhere in the HyperScale configuration where I can set the multipath setting or does anyone have any suggestions on how to utilize both ports on the HBA in a HyperScale setup?
Regards
-Anders