Hi
I have this customer that are using Commvault version 11.32.xx. And this customer only support snmp traps version 2. And when I am looking to configure the snmp traps inside Commvault, I can only see version 3 support.
I am fully aware of the security issues with other version of snmp traps, but is there any way, you can configure Commvault ver. 11.32.xx to use snmp traps version 2?
Many thanks in advance!
Best answer by Brian Bruno
Hi
Commvault software only supports either SNMP version 1 or version 3. Version 2 is not supported. We do have this outlined in our documentation:
Preinstallation Checklist for the CommServe SNMP Enabler (commvault.com)
If your customer is unable to use version 3, can they configure with version 1?
-Brian Bruno
Hi
Commvault software only supports either SNMP version 1 or version 3. Version 2 is not supported. We do have this outlined in our documentation:
Preinstallation Checklist for the CommServe SNMP Enabler (commvault.com)
If your customer is unable to use version 3, can they configure with version 1?
-Brian Bruno
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
