Hello guys,
I’m trying to run a restore from a Mongo Standalone backup, but I’m stuck in this error. Could you please help me?
Tks!
Solved
Getting "error decrypting password" when running MongoDB Standalone Restore
+3Best answer by Albert Williams
Hello Rai,
Our systems assume a clusters MongoDB environment and our documentation is all written with clusters in mind. On our system requirements page you will find the following note to allow a single node environment to work :
https://documentation.commvault.com/2022e/essential/99537_system_requirements_for_mongodb.html
Note: If you have a single node replica set that has only a primary node, add the bMongoDBEnableBkpForSingleNodeRepSet additional setting to the client node that you want to back up.
Due to this we have have any documentation that is specific to non-cluster so my recommendation is to move through the following steps:
https://documentation.commvault.com/2022e/expert/99649_mongodb_restore_operations.html
If you hit any errors or issues, or if the GUI does not allow you to progress due to information about a replica node needed then I recommend raising a support case to review.
Sorry i cannot give you a direct answer but this is the best way forward.
- Vaulter
- 642 replies
Hello Rai,
That error message is seen in our logs a lot and it is not necessary the reason the job has failed.
We have a step to attempt to decrypt data and we will get that error message if the data is not encrypted but move forward with the restore.
The following are all the steps and methods to perform the Mongo DB restore:
https://documentation.commvault.com/2022e/essential/124827_restores_for_mongodb.html
If you could go over all the prerequisite and validate all is covered. If you still are hitting an issue with the restore a deeper dive in the logs may be best investigated under a support ticket or if you can provide further log lines here later on in the jobs life.
Always happy to help!
+3Hello
Ok, I’m using this doc to restore the MongoDB Standalone.
For Standalone restore, is the right doc?
- Vaulter
- 642 replies
- Answer
Hello Rai,
Our systems assume a clusters MongoDB environment and our documentation is all written with clusters in mind. On our system requirements page you will find the following note to allow a single node environment to work :
https://documentation.commvault.com/2022e/essential/99537_system_requirements_for_mongodb.html
Note: If you have a single node replica set that has only a primary node, add the bMongoDBEnableBkpForSingleNodeRepSet additional setting to the client node that you want to back up.
Due to this we have have any documentation that is specific to non-cluster so my recommendation is to move through the following steps:
https://documentation.commvault.com/2022e/expert/99649_mongodb_restore_operations.html
If you hit any errors or issues, or if the GUI does not allow you to progress due to information about a replica node needed then I recommend raising a support case to review.
Sorry i cannot give you a direct answer but this is the best way forward.
+3Hi
Could you please tell me how to add bMongoDBEnableBkpForSingleNodeRepSet?
Tks!
- Vaulter
- 642 replies
Hello
The following goes over the steps for the additional setting and to how add them:
Always happy to help!
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.