Skip to main content
commvault.com commvault.com
Solved

How do I deploy the file recovery enabler for Linux (FREL)?

  • December 30, 2020
  • 4 replies
  • 3853 views
C
Vaulter
Forum|alt.badge.img+2

Any pointers with deploying FREL?

Best answer by Jordan

Hi Christine,

 

This is a common question, so we made a video tutorial on how to deploy it to support restore operations from Linux filesystems.  

 

Check it out here: How to Deploy a File Recovery Enabler for Linux (FREL)

 

Let me know if you have any further questions at all.

 

Thanks 

View original
Did this answer your question?

4 replies

J
Vaulter
Forum|alt.badge.img+11
  • JordanVaulter
  • Vaulter
  • 135 replies
  • Answer
  • December 31, 2020

Hi Christine,

 

This is a common question, so we made a video tutorial on how to deploy it to support restore operations from Linux filesystems.  

 

Check it out here: How to Deploy a File Recovery Enabler for Linux (FREL)

 

Let me know if you have any further questions at all.

 

Thanks 

Scott Moseman
Jean-Christophe Bettinelli
2 people like this
  • Scott Moseman
    Scott Moseman
  • Jean-Christophe Bettinelli
    Jean-Christophe Bettinelli
H
Byte
Forum|alt.badge.img
  • Hansel
  • Byte
  • 2 replies
  • February 6, 2023

Hello,

The video shared on this thread points only to VMware and OpenStack. Do you have any video or guide to configure the FREL for Oracle Linux Virtualization Manager? I went through the documentation but have some doubts, to be specific on below point:

 

  1. Add a disk or volume with the XFS file system and create the following mount point for cache data:

    • For FBR cache: 40 GB minimum

Which mount point should we use, is it a new one with any specific configuration?

Hope you could help me, thanks in advance.

S
Vaulter
Forum|alt.badge.img+14

Hi @Hansel ,

There is no specific configuration:

You just need to create an independent device(disk partition or logical volume), then mount it.

For ex:  mount it to /opt/FBR and then add "dFBRDIR /opt/FBR" in Session reg key.

Best Regards,

Sebastien

H
Byte
Forum|alt.badge.img
  • Hansel
  • Byte
  • 2 replies
  • February 16, 2023

Hi @Sebastien Merluzzi ,

Thanks for your reply. We are working on this configuration. If facing challenges/issues, I will post again seeking your guidance. 

Regards. 

Reply


Most helpful members this week

Terms & ConditionsCookie settings

Cookie policy

We use cookies to enhance and personalize your experience. If you accept you agree to our full cookie policy. Learn more about our cookies.

 
Cookie settings