Good afternoon.  You can go into the Command Center and run a Job Summary report.  This will show you the job status on each job.  You will see some that show “No Run” or “Delayed” as well as the other more common statuses.

@JuanPa , are you referring to what was scheduled vs manually run?  The report @Orazan referred to should show the ‘Run By’.

Hi, 

I need to compare what was programmed against what was executed to get the number, I see the report that @Orazan 

 mentions, but I cannot filter or make it give me unique Job IDs.

@JuanPa Hello,

I would like to confirm that you are looking to see what is scheduled by that has Actually run.

Can you confirm this?

To clarify what @Orazan is stating there is a job status that shows No run if a scheduled job did not run.