I’m new to CommVault. I read and followed the instructions for installing the Log4J vulnerability fix, but I’m not sure if I did it correctly/Successfully. Does anyone know of a way to verify that the fix is actually installed on one of my client computers?
Answer
Validating the Log4J patch
- Novice
Best answer by MichaelCapon
Hi
- In the CommCell, right click the Client that you installed the patches on.
- Select Properties.
- In the Properties page, Check the “version” Tab.
- This should show any updates applied to the client.
Also the UpdateInfo.log log file on the Client (In Commvault Log Files directory) would also show the Patch.
Best Regards,
Michael
+14- Vaulter
- Answer
Hi
- In the CommCell, right click the Client that you installed the patches on.
- Select Properties.
- In the Properties page, Check the “version” Tab.
- This should show any updates applied to the client.
Also the UpdateInfo.log log file on the Client (In Commvault Log Files directory) would also show the Patch.
Best Regards,
Michael
- Novice
Hey
so I copied the Log4J windows updates and Linux updates to the cache. I see them in there..
SNIP:
When I performed the upgrade software option I noticed on my windows clients I only see 1 of the 2 windows patches? Im wondering why
Snip
same with my linux clients:
Do I need to perform the upgrade one patch at a time? or are both patches needed? Im a little confused. Im not proficient with commvault.
I was expecting to see both “4562” & “4563” for windows clients and both “4561” & “4563” for the linux clients. Please advise.. Thanks
Thanks
BC
+22- Vaulter
Hi
We cover this in the main thread (link below). Not all of the updates apply to each agent, so some are Commserve only and some are client only.
As long as you use copy to cache (which it looks like you did) and the report says you are clear, then you’re good.
https://www.linkedin.com/in/michael-struening
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.