Questions about scheduling and AUX copies

Hi @tigger2 

You can rename schedules without breaking it, no re-association needed.

Regarding your second and third points, I would use the continuous option in the schedule. This allows to start a job x minutes after the last job ended. The default schedule is 30 minutes. If a job already runs then it checks again later to see if the schedule parameters are met and a job needs to be started.

https://documentation.commvault.com/2022e/expert/6699_creating_continuous_schedule.html

Hope I interpreted this question correctly. Contention is always possible if the same drives are requested for certain jobs, but the system allows claims only when the resources are available preventing an actual issue. Jobs requesting unavailable resources will wait untill resources become available. Schedule staggering will definitely help and you could also set job priorities to give priority to certain activities.

https://documentation.commvault.com/2022e/expert/6516_job_priorities_and_priority_precedence_advanced.html

Regarding the data threshold as a trigger for an auxcopy, I do not believe there is an option out of the box, but I can check later on. Can't check this now unfortunately. If not possible out of the box, I am almost sure you could realize this via REST API. I will get back on this if no one answered this already before I can check.

Hope this helps.

Hi @tigger2 

Regarding the data threshold trigger, there is no out of the box option to define an amount of data.
I do have some workaround ideas which can create a similar delay / trigger:

• Defer Auxiliary Copy for n day(s)

  Specifies that data can be copied to this copy only after an n amount of days after the data was protected. So the amount of data is not fixed, but it will allow you to perform copies in a manually set frequency based on the initial protection date without modifying your auxcopy schedule.
  
  This setting can be found within the Copy Policy tab which is in the properties of a storage policy copy.
   

  

• Manually configure a trigger based on data amount using the Fallen Behind setting on SP Copy
  
  Exclude the storage policy copy from the auxcopy schedule.
  Set your storage policy copy fallen behind value to the required data amount on which you want to trigger an aux copy.
  Create a new alert specific for the SP copy involved, based on Job Management - Auxiliary Copy
  Select the SP copy
  Check the box for Auxiliary Copy fallen behind alert
  Use the Run Command to run a script to initiate the aux copy.
  
  This script specific for this SP Copy can be created by manually right clicking the SP involved, select All Taks - Run Auxiliary Copy. Define the copy and select Save as Script.

I also checked the REST API method, but I can't seem to find the fallen behind trigger there.
So as far as I can see this is not an option.

Hope this helps.

Thank you so much @Jon Vengust @Jos Meijer !

Info: All of our schedules/copies/etc. were made by several people in the past and essentially batches of similar copy types will all “kick off” at the same time. It’s very ‘simple/basic’ and I think it worked well for when we had less data to back up but it appears to causes a lot of Aux copies to run at the same time and slow down their overall throughput (we have some physical hardware limitations we will be alleviating in the future), as well as most of the tape jobs run at the same time and go to pending and seem to slow down the system as well as we have fewer drives than Aux tape jobs are configured for.  Whenever we have to do something heavy like DDB data verification or a job simply backs up (due to issues, say tape drive failures or a lot of new data is being backed up) it can take a long time for Aux copies to catch up.

I think all this information will help me make some scheduling changes and spread out the CPU/job load a bit better without complicating it too much. Thanks again!