Hyperscale temperature monitoring data report/Alerts

@Prem , at this time there are no temp monitoring tools on HSX.  This is something that can can be monitored with tools over SNMP or configure the IPMI to send email.

Thanks for the response @Mike Struening .. Just curious to know if adding this feature is in pipeline with Commvault at least with HyperscaleX, as it might be very helpful to have this monitored.. 

Not that I am aware of, though you should be able to open a CMR via your incident (happened to see you had one opened for this).

That way it’s on the radar.

Thanks again @Mike Struening .. Will do.

Hi @Prem 

There are plans in pipeline to monitor additional HW devices like FAN, PSU, etc. So if there is a temperature rise we would send alerts. This would be available in Command Center.

Data gathering of high, average, etc. is still not clear. This would be for both Appliance and Reference Architecture.

Thanks for this @R Anwar I have a question here, temperature rise as in if it crosses the threshold or  exceeded the suggested ambient temperature whether it will throw a alert ?. 

Regarding Data gathering of high, average etc as in I meant, If we can pull out a report where it can show the temperature of the hardware devices based on the time range.. like 8AM it is X degree Celsius..  

Thanks, @Prem !  I’ll mark that as the best answer so everyone who comes looking can find it.