+4Hey! I am developing automation scrips using Commvault APIs for my team. I know the names of primary commserve which I use, BUT whenever a failover happens my API calls of course don’t work as there is no web service active on the primary commserve.
Is there a way to know which node the failover happened to using just the APIs? And also get the list of all failover nodes?
Best answer by Albert Williams
Hello
Thanks for the great question.
The following will return the hostname of the CS:
https://api.commvault.com/docs/SP34/api/cv/ControlPanelOperations/get-comm-serv#get-commserv-details
The following will give you Monitoring nodes and fail over nodes:
https://api.commvault.com/docs/SP34/api/cv/CSLiveSync/get-comm-serv-failover#fetch-cslivesync-config
I’m not sure if you can find your answer here but these two would be where i start.
Kind regards
Albert Williams
Hello
Thanks for the great question.
The following will return the hostname of the CS:
https://api.commvault.com/docs/SP34/api/cv/ControlPanelOperations/get-comm-serv#get-commserv-details
The following will give you Monitoring nodes and fail over nodes:
https://api.commvault.com/docs/SP34/api/cv/CSLiveSync/get-comm-serv-failover#fetch-cslivesync-config
I’m not sure if you can find your answer here but these two would be where i start.
Kind regards
Albert Williams
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
