The virtual machine reports that it has virtual disks that need consolidation and this could not be performed automatically. In order to prevent a further buildup of delta disks and possible stability issues with the virtual machine, further backups of this virtual machine will not be performed until this condition is corrected. Please check if there are any locks on the virtual disks or if the disks are still attached to a backup proxy. Unable to access file since it is locked Virtual disk file that is attached to virtual machine.
Solved
Getting Disk consolidation error & Unable to access file since it is locked Virtual disk file that is attached to virtual machine.
+1Best answer by Christian Hansen
Hello
In most cases this is due to Hotadd locking the disks on the Proxy machine. Can you confirm if you are using Hotadd Transport Mode for your backups?
Transport Modes for VMware
https://documentation.commvault.com/commvault/v11/article?p=32037.htm
If you are there are few things to check here:
- -Within VMWare verify if there are any disks present on the Proxy machine(s) that do not belong to the Proxy VM
- -Within the Guest OS check is automount is enabled
- Open Command Prompt as Admin
- Go into disk part with the “diskpart” command
- Once diskpart loads type the command “automount”
- If this is enabled ensure there are No VSA backup running
- Run the “Automount disable” then “automount scub” commands
- Check AV Exclusions on the Proxies(https://documentation.commvault.com/commvault/v11/article?p=8665.htm)
- Vaulter
- 2 replies
- Answer
Hello
In most cases this is due to Hotadd locking the disks on the Proxy machine. Can you confirm if you are using Hotadd Transport Mode for your backups?
Transport Modes for VMware
https://documentation.commvault.com/commvault/v11/article?p=32037.htm
If you are there are few things to check here:
- -Within VMWare verify if there are any disks present on the Proxy machine(s) that do not belong to the Proxy VM
- -Within the Guest OS check is automount is enabled
- Open Command Prompt as Admin
- Go into disk part with the “diskpart” command
- Once diskpart loads type the command “automount”
- If this is enabled ensure there are No VSA backup running
- Run the “Automount disable” then “automount scub” commands
- Check AV Exclusions on the Proxies(https://documentation.commvault.com/commvault/v11/article?p=8665.htm)
1 person likes this
+4- Vaulter
- 11 replies
Hello
Just seeing if you got a chance to take a look at the solutions provided by Chris_H and if there’s any updates on this thread?
+1Hi
Thanks for your swift reply.
In my environment transport mode is Hotadd. I have disabled the automount option as well. Av exclusions are also in place.
+14- Vaulter
- 349 replies
Hi
I’d also suggest the following:
Make sure the VSA Proxies and vCenter Appliance (If applicable) are not Snapshotted/Backed-up during the VM backup window.
If using VMware 6.5 or higher, Ensure the VM VSA Proxies are using VMware’s Paravirtual SCSI Adapters.
Best Regards,
Michael
Reply
Rich Text Editor, editor1
Editor toolbars
Press ALT 0 for help
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.