Skip to main content
Solved

When Commserve livesync failover to standby server?


Forum|alt.badge.img+6

Hi,

 

I understand that conditions must be satisfied before a failover (CS Livesync) is automatically executed (if enabled)

I have a question about this.

Does this immediately happen after these conditions are met or does it wait and checks it the conditions a (few) minutes later again before going over?

And if that there is some delay, is it configurable?

 

Thanks,

Danny

Best answer by Orazan

Good morning.  The delay is not configurable, at least not at this time.  The conditions are that we check that the connections are good both ways every five minutes as well as checking several other settings in the registry.  If these fail, it will initiate the auto-failover.

View original
Did this answer your question?

3 replies

Forum|alt.badge.img+15
  • Vaulter
  • 630 replies
  • Answer
  • July 15, 2022

Good morning.  The delay is not configurable, at least not at this time.  The conditions are that we check that the connections are good both ways every five minutes as well as checking several other settings in the registry.  If these fail, it will initiate the auto-failover.


Forum|alt.badge.img+6
  • Author
  • Byte
  • 21 replies
  • July 15, 2022

Thank you Orazan,

So to be short, failover will happen between 1 sec and 5minutes if all conditions are satisfied


Forum|alt.badge.img+15
  • Vaulter
  • 630 replies
  • July 15, 2022

Yes that is correct.  ðŸ˜€


Reply


Cookie policy

We use cookies to enhance and personalize your experience. If you accept you agree to our full cookie policy. Learn more about our cookies.

 
Cookie settings