Hi All,
I had some issues with VM replication terminating with error. After marking for full sync the replication finished successfully.
Now the problem is that every following replication replicates the same amount of data as the full replication did. Because full replication takes 7 days to complete I would like to avoid deleting the target VM and configuring the replication from scratch.
What could be the reason for replicating such huge amount of data? How could it be fixed?
Regards,
Lubos
Is this VMW-VMW replication, it should not be doing full replication. we need to check why its doing full replication. Unless GUID of VM changes it will not run into these issues. can you get this issue escalated with logs.
Thanks!
Sharing the resolution from the case:
we temporary disabled the synth backup until it copied all the incremental backup
now after in sync we have enabled the synth full backup and jobs are in sync
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
