i would like to know the sync time for the hyperscale x hardware status , we have removed network card from nodes but it doesnt reflected in the command center same time , it took around a day to update , is there any way to get it same time
Solved
Hyperscale hardware status -sync time
- Explorer
Best answer by Collin Harper
Hello
We run Health Check updates every 30 minutes by default. Unless this setting has been increased, the Command Center should update within 30-60 minutes of any changes.
https://documentation.commvault.com/2023e/expert/media_management_configuration_service_configuration.html
(It does say Space Check, but we do the Health Check during the Space Check so this setting controls the Health Check interval).
Thank you,
Collin
- Vaulter
- Answer
Hello
We run Health Check updates every 30 minutes by default. Unless this setting has been increased, the Command Center should update within 30-60 minutes of any changes.
https://documentation.commvault.com/2023e/expert/media_management_configuration_service_configuration.html
(It does say Space Check, but we do the Health Check during the Space Check so this setting controls the Health Check interval).
Thank you,
Collin
- Explorer
It does say once in 24 hours by default and how are you achiving 30 mints when the range is start from 60
- Vaulter
Hello
Sorry I was mistaken. This value must have been updated from 30 to 60 since last I checked.
Thank you,
Collin
Readiverse Academy Certifications
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.