Hi,
I understand that conditions must be satisfied before a failover (CS Livesync) is automatically executed (if enabled)
I have a question about this.
Does this immediately happen after these conditions are met or does it wait and checks it the conditions a (few) minutes later again before going over?
And if that there is some delay, is it configurable?
Thanks,
Danny
Best answer by Orazan
Good morning. The delay is not configurable, at least not at this time. The conditions are that we check that the connections are good both ways every five minutes as well as checking several other settings in the registry. If these fail, it will initiate the auto-failover.
Good morning. The delay is not configurable, at least not at this time. The conditions are that we check that the connections are good both ways every five minutes as well as checking several other settings in the registry. If these fail, it will initiate the auto-failover.
Thank you Orazan,
So to be short, failover will happen between 1 sec and 5minutes if all conditions are satisfied
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
