I have an Auxcopy Source (HYperscale-X), destination (Hy7perscale). I have max numbers of readers set and multiple mount paths set on the Copy.
I have thousands of jobs in the Auxcopy, yet only one stream gets allocated.
What am I missing?
- Vaulter
- 133 replies
-
15 September 2022
Check:
- # of readers on aux copy job/schedule
- # of device streams on Storage Policy properties
- Max parallel operations on each MA (usually wouldn’t be this unless there are hundreds of other jobs running on the same MA’s right now)
+5
None of those. What I did notice is that the destination copy was not deduplicated (some one has set this up adhoc), when I repointed destination to same storage with deduplication the number of streams improved.
- Vaulter
- 133 replies
-
15 September 2022
If destination copy was not deduplicated, did it have combine to stream enabled? If so, it may have been set to 1?
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.