Good morning, I have a library with two drives, and I need the copy to use only one drive, leaving another drive free for another copy. As of today, when a copy is launched, it uses all available drives, and the second copy is put on hold. I saw that the copy is configured with 100 streams. Should I lower that to 1? Could you guide me so that each copy launched to tape uses only one available drive.
Question
auxiliary copy to tape
+1
+20- Commvault Certified Expert
I think this is what you are looking for: https://documentation.commvault.com/v11/commcell-console/auxiliary_copy_troubleshooting.html#mm2012-auxiliary-copy-job-uses-too-many-tapes
+1Good morning. Looking at the documentation, I don't see the same thing reflected in the console. Should I change the streams in the schedule policy and leave it at 1?
+20- Commvault Certified Expert
Are you looking in the legacy Commcell console? Because this is where you should look in this example. Which version are you running?
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.