Configure data & storage network IP if Hyperscale

For HyperScale X appliances you can configure the Management Interface (IPMI), connect to that interface, open the console and run hsxsetup

This will start a wizard which will allow you to setup the cluster 🙂

P.s. do not use SSH/Putty to perform this config

Hi

You mean “Integrated Remote Management Console (iRMC)” inerface of  appliance, it is interface for Harware configuraiton to setup of bios etc. 

Is there any tool called “Hyperscale Applice browser” for configuraiton 

Thanks

Hi @Aju 

Yes iRMC is what you need 🙂

The name Hyperscale Appliance browser I don't recognize, not sure what this would be referring to.

Hi

One more question do it required that iRMC network and Data protection network should be routed and accessible from each other.

Thanks

Hi Jos

Thanks for support 

Regards