After updating one of my Media Agents to service pack 22.27 this morning, Commvault decides it needed to reconstruct the DDB on that MA. How can I tell what instigated/initiated the rebuild?
Solved
determine cause of DDB reconstruction
+2Best answer by Mike Struening RETIRED
Hey
We should have some detail in SIDBEngine.log, though if I had to give the most likely reason, I’d say the dedupe engine was not completely ready to shutdown.
Did you confirm all operations were completed?
https://documentation.commvault.com/commvault/v11/article?p=12598.htm
The link above isn’t long, but details what could happen if you don’t let everything finish.
+23- Vaulter
- 4996 replies
- Answer
Hey
We should have some detail in SIDBEngine.log, though if I had to give the most likely reason, I’d say the dedupe engine was not completely ready to shutdown.
Did you confirm all operations were completed?
https://documentation.commvault.com/commvault/v11/article?p=12598.htm
The link above isn’t long, but details what could happen if you don’t let everything finish.
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.