+4Helo team,
Hello team,
I have a problem when configuring Oracle Linux virtual manager, I have created a proxy (VSA) with Oracle Linux 8.5 OS but when I select the access node for the proxy it does not come out.
Additional information proxy using VM installed in OLVM itself.
Is there a requirement that is missing
+22That's strange! Assuming you select the correct hypervisor I would say you are hitting a software defunct. Are you running the latest maintenance release? I would open a ticket in case you do run the latest maintenance release.
+12Hi
Can you make sure if all the pre-requisites mentioned here are met?
Converting a Linux MediaAgent to a Linux Access Node
If they are met, can you try adding the additional setting on the CS properties: Additional Setting: ShowAllVSAProxies with value 1 and see if it shows up?
Best,
Rajiv Singal
+4Hello
Thanks for your answering,
Yups for hypervisor is correct OLVM use hypervisor for Redhat
+4Hello
Thanks for your answering,
I use that requirement but I'll try to check it again later because it's visible from the command center but not from the console
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
