Hello,
I am trying to create workflow for VM backup and restore.
I have used predefined workflow Demo_FileSystemBackupRestore and tried to modify it for VM.
Everything goes fine until it gets to restore phase where I get Error 0x303: Q_VIRTUAL_SERVER iDataAgent is not supported by this command.
Thanks for any suggestions,
Michal
Hi
The restore part of the workflow probably needs to be replaced with a qcommand and virtual server XML - you can get the XML by running a restore and then using “save as script” and put it into the workflow.
Hi
I was on vacation,
and thank you for pointing me out in the right direction, using ExecuteScript in Utilities I was able to run a restore.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.